Wednesday, September 26, 2007

How to draw the 3D box

How to draw the 3D box

To draw the 3D box

Step 1

To draw the 3D box, the first thing you must do is to use the mouse to move to Surfaces toolbar and then click the Box command.

Step 2

Later, you must set the following;

  1. Center/ <0,0,0>:

  2. Cube/Length/:

  3. Cube/Length/:

  4. : 100

Step 3

Later, use the mouse to move to Viewpoint tool bar and then click the SW Isometric View command.

Step 4

Finally, you could see that the Box image has appeared on your screen.


Edited By: Norasyikin Mahmud

© 2001 ISC

All rights reserved. All other product names and trademarks are registered properties of their respective owners.

011101

How to draw the Edge surfaces

How to draw the Edge surfaces

To draw the Edge surfaces

Step 1

To draw the Edge surfaces, the first thing you must do is to set the new value for SURFTAB1 <20>: 25. After that, use the mouse to move to Surfaces toolbar. Next, you need to click the Ruled Surfaces command.

Step 2

After that, just select the path curve and then select the axis of revolution. Later, you must enter the Start and the Included angle.

How to draw the Ruled Surfaces

How to draw the Ruled Surfaces

To draw the Ruled Surfaces

Step 1

To draw the Ruled Surfaces, you need to set the following;

  1. New value for SURFTAB1 <20>: 25
  2. Use the mouse move to Surfaces tool bar
  3. Click the Ruled Surfaces command

Step 2

Next, you need to select the first defining curve: and after that, select the second defining curve: as shown by the picture below.

How to draw the Tabulated Surfaces

How to draw the Tabulated Surfaces

To draw the Tabulated Surfaces

Step 1

To draw the Tabulated Surfaces, you need to do the following;

  1. New value for SURFTAB1 <20>: 25
  2. Use the mouse move to Surfaces tool bar.
  3. Click the Tabulated Surfaces command.

Step 2

After that,

  1. Select path curve:
  2. Select direction vector: